Menu

© 2012 BlogName - All rights reserved.

Firstyme WordPress Theme.
Designed by Charlie Asemota.

Need parts for Ford Differential

December 11, 2014 - Author: BartBarton

I have a Jeep 1995 2.5L YJ

Question:  I’m purchasing a used 97 ford explorer L.slip rear axle assembly, it’s an empty case. need to know what i’ll need to set it up with Limited slip 31 spline 4.56 gears. want to put together budget and get started with purchases. any help would greatly be appreciated.

Answer:

Below is a parts list for a Ford 8.8 rear differential you can pick the parts you need:

  •  RING & PINION  MOTIVE part number F888456   or YUKON GEAR part number YUKON    YG F8.8-456  4.56 ratio   your cost $210.50
  • BEARING KIT part number R-88  your cost $98.59
  • AXLE  BEARING part number 6408  your cost $11.02 EACH
  • AXLE SEAL part number 8835S your cost $3.26 EACH
  • REAR AXLE SHAFTS part number F5TZ4234A and F5TZ4234B $95.92 each

There are a couple of options for positraction units

  • FORD LIMITED SLIP part number 2L2Z4026AA  your cost $231.57
  • EATON LIMITED SLIP (THIS WOULD BE MORE PERFORMANCE ,SRONGER THAN THE FORD T/L) Part number 19588-010 your cost $464.52
  • PINION FLANGE (THIS WOULD BE THE STOCK FORD FLANGE, MAY BE ABLE TO CHANGE TO SOMETHING ELSE DEPENDING WHAT YOU ARE DOING ON THE DRIVE SHAFT) part number E9TZ4851A your cost $42.54 plus freight.

Give Lance or James a call 800-444-0755 they can help you.  You can see the other rear end part that we can provide on our site.

No Comments - Categories: Axles

Rear Axle for 1990 Chevy 1/2 ton Pickup Truck

March 25, 2014 - Author: BartBarton

I have a Chevy 1500 1990 V8 4WD.

Question:  I need to order the driver side rear axle, I live in Alaska and need to be 100 percent sure I am ordering the correct axle what information should I supply.

Answer:  Check out he illustration below and supply the information identified in this drawing:

rear_axle_illustration

You can see a complete list of axles we can provide on our site.  Take advantage of our technical expertise give us a call at 800-444-0755, we have the information you need.

No Comments - Categories: Axles

Camaro Bent or broken axle

March 18, 2014 - Author: BartBarton

I have a 1990 Chevrolet Camaro

axles

New Replacement Axles

Question: In the rain I spun out and hit the curb with the rear wheel, is it possible I bent the axle?

Answer:  Broken axle simple to identify as the wheel in most cases will fall out, this event could be preceded by noise, really dangerous stop vehicle do not drive. Bent axle typically happens when vehicle spins out or slaps a curb you might not observe damage (you may hear a high pitched squeal).  It has been reported that higher horsepower sports type cars can bend axle by wheel hopping.

If you feel vibration, start by removeing the wheel and tire, take it  to tire shop and have them put on balance and check for a bent wheel. If the wheel isn’t bent you must or have someone remove the axle put  the head of the axle just off the edge of a table, then roll the axle along the edge you should be able to observe bend. If the axle or axle head wobbles, you have a bent axle. And must replace the axle.  You can see the full line of automotive and pickup axles we can provide on our site.

No Comments - Categories: Axles

Axles

January 3, 2014 - Author: BartBarton

Axles are available for both 2WD and 4WD vehicles and we also carry a wide range of ATV axles.

No Comments - Categories: Axles